21
a
ppendix...
gB
ie
Wd140CL Warmer drawer
installation
Positioning the appliance in the housing unit
Push the appliance into the housing unit as far as the vapour strip and align it.
[05]
[05]
note!
Ensure that the housing unit is aligned at a right angle.
•
Open the drawer, and use the 2 screws [05] and plastic supports [02]
supplied to secure the appliance to the side walls of the housing unit.
•
The appliance is supplied with three metal trims [03] which have an adhesive
underside. These trims must be stuck on to the drawer so that they seal any
gaps between the housing unit and the drawer (fig 1).
•
Then position the side trims x2 as shown in Fig 1 so that they are flush with
the side walls of the housing unit and If the unit does not have a back wall
you do not need the third trim. If the unit has a back, position the back trim x1
as shown in Fig 1, so that it is flush with the back wall of the housing unit.
WD140CL-C&L-A5-GB-IM-08.indd 21
11/4/13 3:02 PM