4
How to operate
Starting your new thermoelectric cooler
1.
a clean moist cloth.
2. Insert the power supply cord into the socket.
Normal operating
When the cooler works with full power, the two LEDs on the circuit board will flash.
The red one shows the power input status. The green one shows the output status of
the cooling system. Meanwhile the fan inside the cooler begins to work. When the
door is opened, the light under the temperature adjustor will turn on automatically.
The temperature range for cooler is 8°C to 18°C/12°C to 18°C. When the temperature
is set on one certain point and the temperature inside reaches this point, the automatic
temperature control system begins to work and the cooling system goes into linear
temperature keeping status.
Note:
Wait 3-5 minutes before restarting if you unplug the cooler. The unit may fail to
operate properly if restarted too quickly.
Clean the cooler thoroughly. Wipe the outside with a soft dry cloth, the interior with
How to clean
Cleaners:
Never use harsh, abrasive cleaners, heavy-duty cleaners, or solvents on
any surface.
Exterior:
Wipe with damp, sudsy cloth, rinse and dry. For stubborn stains and for
periodic waxing, use silicon wax.
Cooler Section:
Wash shelves and other removable parts in warm sudsy water,
rinse and dry. Wash interior with baking soda solution (3 tablespoons to I liter of
water) or warm sudsy water, rinse and dry.
Magnetic Door Seals:
Wash with warm sudsy water.
The Finishing Touch:
Replace all parts and return thermostat dial to desired setting.
How to install
Install cooler in a convenient location
away from extreme heat and cold.
Allow sufficient clearance between the
cooler and side wall so the door will
open without obstruction. Cooler is not
designed for recessed installation.
Select a space with strong level floor.
Allow 2 inches (5cm) of space between
the cooler's side & wall and 4 inches
(10cm) between back & the wall.
4 inches
2 inches
2 inches
