There are certain safeguards that must always be followed whenever the
FlashPak PTDS is used. To reduce the risk of fire, electrical shock or injury,
be sure to read all of the following:
Read and follow all instructions carefully.
• The FlashPak PTDS charger in the United States is equipped with a three-prong
electrical plug. This three-prong plug is part of a system that will protect you
from serious injury if something goes wrong with the electrical wiring in the
charger. Be sure the three-prong plug is plugged into a matching three-prong
socket that’s properly grounded.
WARNING!
DO NOT cut or break off the
large third prong in this plug, or change the plug or power cord in any way.
• Make sure that incoming voltage matches unit requirements. A product identifi-
cation label on the bottom of the charger specifies the operating voltage,
wattage, current, frequency, and phase of unit. Plugging or wiring the charger
into a power source differing from the unit rating may significantly decrease the
performance or severely damage electronic components.
• Unplug the charger before cleaning.
Do not submerge the charger in water.
Do
not splash or pour water onto the charger’s control panel or into intake/outlet
vents. Possible shock hazard may result and the unit may be damaged.
• Do not use steel wool or abrasive cleaners on the metal housing or plastic
locator tray surface.
• The FlashPak PTDS chargers and pellets are intended for use with CookTek
designed and approved pizza bags only. Do not attempt to use unapproved or
damaged pizza bags, trays, or pellets.
• Do not place foreign objects on the charger, or between the pizza bag and
charger. Foreign objects placed on the charger or between the charger and bag,
or inside the bag may overheat and cause damage to the charger and/or bag.
• Do not use any PTDS charger that has a damaged cord or plug. Consult the
warranty and follow instructions for service.
• Do not let the PTDS charger cord touch hot surfaces.
• Please do not attempt to open the unit or perform service of any kind.
This
product can only be serviced by a CookTek Authorized Service Agent or
designated CookTek personnel.
Contact CookTek at (312) 563-9600 for
service information.
• The charger top may get hot to the touch after hours of continuous use. Use
caution when loading and unloading pizza bags.
• Do not place any objects in the pizza bag while it is on the charger.
Every installation site has different electrical wiring requirement. Because many
different local codes exist,
it is the Owner and Installer’s responsibility to
comply with ALL applicable codes.
CookTek is not responsible for any conse-
quential damages, either expressed or implied, as a result of failure to comply with
installation requirements.
A dedicated electrical line is recommended for EACH FlashPak PTDS Unit.
3
