• When the bag has completely charged, the green “READY” LED will illumi-
nate indicating that the bag is fully charged and is now ready for delivery.
Charge time for cold, or room temperature bags will be approximately two min-
utes. After the first charge, recharges will take approximately 60 seconds or
less, depending on the residual energy in the bag/pellet.
• When an order is ready for delivery, remove a charged bag from any FlashPak
PTDS with an illuminated green “READY” LED.
• Immediately place another bag on the FlashPak PTDS making sure that the red
“CHARGING” LED illuminates.
• Make sure that a bag is on the FlashPak PTDS (s) at all times. This will ensure
that all deliveries are made with a heated bag.
• Each evening before you close your store, turn off all FlashPak PTDS’s by
depressing the “POWER” button. All membrane panel LED’s should turn off.
NOTE: The cooling fan will continue to run and will turn off approxi-
mately 20 seconds after the power is turned off.
TROUBLE-SHOOTING
The CookTek FlashPak PTDS is a very intelligent device. Built in diagnostics can
help you to determine the cause of most problems. The following section explains
how to determine if you are experiencing a problem and what can be done to cor-
rect the problem. This information can be very helpful if you are calling our
Customer Service department to report any operational difficulties.
• Errors are indicated by a number of consecutive audible “beeps” and the
repeated flashing of the reset LED.
• If an error occurs, remove the bag from the charger and depress the RESET
button. Make sure that the bag is properly positioned on the charger.
• When the “POWER” LED illuminates, place the bag back on the unit to con-
tinue charging.
• If an error persists, remove the bag from the charger, turn the power off and
unplug the unit, with the unit unplugged press the “POWER” button (panel
LED’s may momentarily flash), plug the unit back in and turn the unit on by
pressing the “POWER” button.
• When the green “POWER” LED illuminates, place the bag back on the unit to
continue charging. Make sure that the bag is properly positioned on the charger.
NOTE:
If the FlashPak PTDS unit does not see any activity for an extended
period of time, you will initially hear 2 beeps and then you will see the “POWER”
LED flash constantly. This is
NOT
an error code, merely an indication that the
unit has entered a power saving “sleep” mode. To exit “sleep” mode press the reset
button.
5
