ISSUE 1 29/6/2017
4
4. Lower the lever firmly so that the cutting blade pierces the lid
this will start the can opener working automatically and the can
will rotate
.
It is not necessary to hold the lever or the can during
operation.
5. When the can is fully open the can opener will stop.
6. Open cans for a maximum of 1 minute of continuous use.
7. The cut edge of the can and the lid will be sharp. Take care not to
touch either when removing the can and the lid from the opener.
Hold the can, lift the lever and remove the can from the opener.
The lid of the can will be retained by the magnet
.
8. The can opener can be stopped at any time by lifting the lever,
removing the plug or switching off at the mains.
Notes:
This can opener is suitable for opening round rimmed cans with
maximum dimensions - height 175mm, diameter 50 - 100mm,
weight 0.6kg. For cans above 0.5kg, the top of the opener will
need to be stabilized with one hand.
The can opener is not suitable for opening rimless, aluminum,
pressurized cans, cans with angled corners, or cans that are
designed to be opened by another method (e.g. pull tab, peel off,
rolling key etc.).
Badly dented cans may cause the opener to stall. If this happens
grasp the can and manually guide it through the cutter until the
damaged area has been passed.
To open a can that has become jammed, hold the can, lift the
lever and release the can. Restart the cutting procedure again on
a new place on the can.
Summary of Contents for CO2061-V
Page 8: ...ISSUE 1 29 6 2017 8...
