www.cool-icam.com
© 2001 TCG.
EN FL Version 3 0801
Page 37
For Macintosh™ Users:
Symptom
Problem
Solution
I receive an error message when I am
installing the
Digital Camera Driver
.
Digital Camera Driver
does not load.
Shut down all other applications and attempt to
re-install the driver, or download the updated
driver from www.cool-icam.com and install the
updated driver.
"STV0680 Capture" / "WWL Mac
Import"
Plug-in file and
"STV0680
Camera Snapshots" / "WWL Mac"
folder is not found in the Hard disk after
I have installed the driver.
All the images I have taken do not
appear on the
Stylus 1500
.
Install the software, restart your Mac, and
finally, connect the
Stylus 1500
to the Mac via
the USB port, then the plug-in file and folder will
appear in the Hard disk.
The installer for the
Digital Camera
Driver
requires the
Stylus 1500
be
connected to the Mac (via the USB) after
the software has been installed & the Mac
restarted.
Insufficient battery power.
Upload all images to your Mac as soon as
possible. (please refer to Battery Guidance
section in User’s Manual.)
You have lost power to your
Stylus 1500
by either:
Removing the battery without being
connected to your Mac (turned on) via
the USB cable.
I receive a message no image to
download.
LCD display is flashing.
Check all cables connections are secured.
Connection failure.
Battery power is too low to continue
taking images.
Upload saved images immediately, then replace
battery.
I
cannot
run
the
STV0680
Capture/WWL Mac Import
.
Conflict with another camera driver
capture device.
If you have any other camera installed on your
computer, remove the camera and it’s driver
completely from your system to avoid conflict
with another camera or capture device.
I hear a low "beep" when trying to take
an image.
Insufficient light.
Take your images in better light condition.
I cannot access any PhotoFantasy's
templates.
No CD in CD-ROM drive.
Put Digital Camera CD in CD-ROM drive.
Please also refer to the help files & User Guides that accompany the enclosed applications.
For further information and support, please visit our website: http://www.cool-icam.com
MAC
My
Stylus 1500
LCD displays " ".
If you need to change batteries, and retain the
images in your
Stylus 1500
’s memory, ensure
you are connected to a Mac which is turned on
via the USB cable, which will then draw power
from the Mac whilst you insert fresh batteries or
make sure there is sufficient power on the
backup battery.
If you need to change batteries, and retain the
images in your
Stylus 1500
’s memory, ensure
you are connected to a Mac which is turned on
via the USB cable, which will then draw power
from the Mac whilst you insert fresh batteries or
make sure there is sufficient power on the
backup battery.
This means there is insufficient power to
upload images to your computer.
is displayed.
Replace or insert a CR2032 battery.
means your backup battery has low
power or is missing.
My image is too dark even though I
used the Flash Bar.
The Flash Light is obstructed by
something.
The Flash Light is not switched on.
The LED indicator is not lit up.
Keep hands and garments away from the Flash
Light. Hold the base of the
Stylus 1500
with the
left hand and operate the Shutter Button and
Mode Button with your thumb and forefinger.
My Flash Bar will not operate.
Check the Connection.
or
Install 2 x AAA Batteries.
or
Switch the Flash Bar to ON and check to see if
the LED lights up. If the LED is continuously you
have enough power, if the L
E
D fades after
initially coming on or does not come on at all
replace the batteries.
or
Set the
Stylus 1500
to Flash Mode.
My Flash Bar is not properly connected.
or
There are no batteries installed in the Flash Bar.
or
The batteries in the Flash Bar have no or
insufficient power.
or
Stylus 1500
is not set to Flash Mode.
I cannot activate my
Stylus 1500
by
pressing the Mode Button.
Insufficient battery power or batteries is
missing.
Upload all images to your Mac and replace
batteries.