1.
Using funnel (supplied), fill the fan’s
internal water tank with clean tap or
distilled water (Do NOT overfill)
2.
Plug
AC cord into fan and wall
3.
Select mist
setting HI or LOW
4.
Select fan speed
setting HI or LOW
What Makes CoolMate Great?
CoolMate’s secret is its patented
“Nano-Mist Generator” misting
head with hundreds of tiny holes
controlled by a micro-chip.
It creates a microscopic mist so ultra-fine it evaporates almost immediately
once in contact with the breeze of the fan. Common, old-fashioned misting
fans use just one single nozzle-hole that squirts out streams of water,
usually ending up as puddles on your floor – CoolMate misting heads are
dripless making the fans suitable for indoor use.
If your fan is not creating mist, it may be for
one of the following reasons:
A
WATER LEVEL TOO LOW or TANK IS EMPTY
SOLUTION:
Refill fan’s
internal water tank and re-push HI or LOW mist setting. DO NOT over fill.
B
AIR LOCK
SOLUTION:
If fan previously ran out of water before the
misting function was turned OFF, an air lock may have formed in the system.
To remedy, gently but firmly shake the fan to unblock the water passages.
C
Mineral deposit on Nano-Mist Generator misting head
SOLUTION:
Gently swab misting head with ONLY cotton tip swab dipped in commercial
cleaning solution noted for removing mineral deposits (such as CLR) or plain
white vinegar. Repeat gentle swabbing several times for thorough cleaning.
NOTE:
Misting function will automatically shut OFF after 4 hours use to
protect mist head should the fan run out of water.
D
If using Cup Holder, fan may operate but will NOT mist if base’s charge
level is too low.
SOLUTION:
Recharge Cup Holder.
Basic Trouble Shooting
Need Assistance or Replacement Parts?
More Info at
www.coolmatefans.com
Email: Customerservice@coolmatefans.com
Unit #18, 170 Wilkinson Road,
Brampton, Ontario CA, L6T 4Z5
CoolMate’s Secret
DO NOT ADD OILS TO
INTERNAL WATER TANK –
APPLY ONLY TO AROMA-
THERAPY ATTACHMENT
Aromatherapy!
Add drops of your favorite
Essential Oils (e.g. Lavender)
to create a cool and scented
theraputic breeze.
Here’s how to do it ...
1.
Turn fan OFF
2.
Remove Attachment
from
back of fan and add several
drops of your favourite
Essential Oil to the fabric
3.
Return Attachment
to
back of fan and
turn fan ON
Important!
Toll Free: U.S. and Canada
1-866-793-7874
Quick Start Guide
Place fan on table top
or other level surface
Getting to Know Your Personal Fan
1.
LOW SETTING: 6-second mist control (mist on for 2
seconds, off for 6 seconds)
2.
HI SETTING: 2-second mist control (mist on for 2
seconds, off for 2 seconds)
3.
Fan Speed ON - LOW/ HIGH / OFF
4.
Refilling Cap (Add water through the [supplied]
1
2
3
4
5
6
7
filter into the fan’s internal water tank. DO NOT spill water
on the fan motor. DO NOT over fill. DO NOT submerge fan
to refill. UNPLUG fan when refilling.
5.
Misting Head (DO NOT TOUCH the Nano-Mist Generator
misting head. It is computer controlled, handle with care)
6.
110 Volt AC power cord
7.
12 Volt DC power cord
Basic Parts and Operation
1
3
4
2
Create a scented
breeze that cools
and rejuvenates!
Fan tilts forward
and back
allowing
you to control the
breeze flow
