Coolster ATV-3050C, Manual

P28

P29

1, the measurement of oil (See left picture) 

  A. Engine preheater minutes. 

  B. When the engine stopped operating, hold on a few minutes 

later, the oil Cypriots will be removed after the oil-observation. 

    C.  The  oil  should  be  located  at  the  highest  and  the  lowest 

among the oil-marker. If the oil level low, should be enough oil 

to rise to the oil-appropriate. 

2, oil and oil filter replacement of the replacement. (

See right 

picture) 

  A. Engine preheater minutes. 

  B. engine will stop. In an engine oil was placed underneath. 

  C. discard release oil bolts, release oil. Put oil may moderate 

shaking body to be inside the engine from impurities. 

Oil

D.  installed  release  oil  bolts,  and  then  full  of  engine  oil. 

Tightening oil Cypriots. 

  I. Starting engine and a few minutes to preheat. Preheat should 

check whether there are oil spills. If it appears that an oil spill, 

should immediately stop engine and check reasons. 

3, the replacement of oil in the second about a month or so to 

clean oil filters

Warning: 

● Do not join any chemical additives. Also lubricating oil clutch, 

clutch slipping and additives will. 

  Note: In the replacement of oil, must be in accordance with the 

following method to check oil pressure. 

1, removed the cylinder covered with oil release bolts. 

2, starter motors, and keep them idle until the oil outflow from 

caving  hole.  If  no  one  minute  after  the  oil  outflow  or  unusual 

phenomenon, should stop the engine running to the nearest 

COOLSTER dealer or repair shop for repair. 

3, after the test should be tightened release oil bolts. 

Carburetor adjustment 

Carburetor is a key part of the car, the need for fine adjustment. 

Most  adjustments  should  be  entrusted  with  the  expertise  and 

experience COOLSTER dealers or repair shops.

Standard Idle: 

          1500 ± 150 to / min

1. Connect speed 

2. Speed Festival through idle screw on the carburetor, idling 

provisions set to rotate within the raise into the engine speed, to 

a decrease in engine speed from

Idle adjustment

Screw ialing

Release oil point