Coolster ATV-3125A, Owner'S Manual

P30

P31

  Note: In the replacement of oil, must be in accordance with the 

following method to check oil pressure. 

1, removed the cylinder covered with oil release bolts. 

2, starter motors, and keep them idle until the oil outflow from 

caving  hole.  If  no  one  minute  after  the  oil  outflow  or  unusual 

phenomenon, should stop the engine running to the nearest 

COOLSTER dealer or repair shop for repair. 

3, after the test should be tightened release oil bolts. 

Carburetor adjustment 

Carburetor is a key part of the car, the need for fine adjustment. 

Most  adjustments  should  be  entrusted  with  the  expertise  and 

experience COOLSTER dealers or repair shops.

Standard Idle: 
          1500 ± 150 to / min

1. Connect speed 

2. Speed Festival through idle screw on the carburetor, idling 

provisions set to rotate within the raise into the engine speed, to 

a decrease in engine speed from

Idle adjustment

Release oil point

Screw ialing

Crankcase emission filter of the circulatory system

1

、

the part works for 150 hours, please cleaning to make 

the part to use normaly.

2

、

take out filter of oil and gas separator, using gasoline or 

kerosene to carry out the washing, and drying.

3

、

in the filter out, remember not to damage the filter.

4

、

the part may clean and use repeatedly in the 

non-damage’s situation.

5

、

the partin use, will be regularly open sewage outfall for 

discharge, the user can also be observed at any time, please 

discharge the squalidity in accordance with the actual 

situation.