UMD V3 Installation Manual - Remote Control
13 November 2018
Page
5
of
39
Hardware Installation Instructions Key Points:
The following Hardware Installation Instructions must be read in conjunction with the detailed information
that follows in the Cooltrax Hardware Installation Ma
nual. The “Hardware” refers
specifically to the Cooltrax
UMD and Wireless Tags.
NOTE: Failure to comply with these instructions will void the Hardware warranty.
1)
The Hardware must be positioned:
a)
in a suitable location where it is not directly exposed to outside weather elements;
b)
where it is not directly exposed to any water or other liquids including water emissions from the
internal workings of refrigeration unit;
c)
where it is not directly exposed to excessive heat, dirt or grease;
d)
in a horizontal alignment where the UMD the LTW connectors are at the top
2)
All cables must be:
a)
enclosed in split tubing up to 150mm from the connectors at each end of the cable;
b)
kept away from heat sources;
c)
of sufficient length so that there is no tension or kinking applied to the cables.
3)
All connectors must be locked into place and tested to ensure they will not come loose.
a)
For the UMD the LTW black connectors with locking sleeve require a quarter-turn
4)
Fixing screws are supplied with the UMD. Do not drill out mounting holes for larger screws as this may
pierce the internal seal and will void warranty.