1. Condenser and ice box
2. Thermostat control
3. Door
4. Shelf x 1
5. Drip tray
O
Do read these instructions thoroughly before using this
appliance.
O
Do install the appliance only in the vertical position.
O
Do stand for 12 hours to allow the cooling gases to
stabilise if transported in a horizontal position.
O
Do install to allow for adequate ventilation around the
appliance (see Figure 5).
O
Do not install near heaters or other heat sources.
O
Do unplug before cleaning and maintenance.
O
Do defrost regularly for maximum efficiency.
O
Don’t install the appliance in humid or extreme conditions.
O
Don’t attempt to repair the appliance yourself (see Helpline
information – back page).
O
Only use it in accordance with the manufacturer’s
instructions.
O
Don’t use any other electrical device inside the appliance to
defrost.
O
Don’t store goods containing inflammable or other
explosive gases.
O
Don’t leave door closed if appliance is left switched off for
long periods.
O
Don’t freeze food in the ice box. The ice box is not suitable
for home freezing.
Page 2
Parts identification
Check the contents
Door reversal
Check the following contents are included with the product and inspect the casing for any damage. If there is any damage, contact
the retailer from whom you purchased the product.
• Removable shelf • Drip tray
After unpacking, wipe the casing with a dry cloth and clean
the inside with a damp cloth ready for use.
1
2
3
4
5
FIGURE 1
Reversing the door may make installation more
convenient. The appliance must be tilted and supported in
order to carry this out; it is therefore advisable to get an
assistant to help during this procedure. Take care when
fitting and tightening screws.
1. Remove the hinge cover, hinge screws, washers and hinge
(Figure 2).
2. Lift the door off the lower hinge pin.
3. Unscrew the lower hinge bracket screws and remove the
lower hinge bracket (Figure 3).
4. Remove the left-hand fixed foot (Figure 4).
5. Remove the adjustable foot from the lower hinge and turn
the hinge upside down. Re-fit the pin and adjustable foot. Fit
the lower hinge to left-hand side of the cabinet.
6. Remove the blanking caps which cover the left-hand fixing
holes and fit them to the holes on the other side of the cabinet.
7. Support the door on the lower hinge pin. Take the hinge and
locate the pin in the bush at the top of the door. Fit the hinge to
the top of the cabinet with the hinge screws and washers. Fit
the hinge cover.
8. Screw the fixed foot into the corresponding hole on the other
side of the cabinet.
PIN
FIGURE 3
FIGURE 2
HINGE PLATE
LOWER
HINGE
SCREWS
AND
WASHERS
ADJUSTABLE FOOT
FIGURE 4
Do and Don’t
HINGE COVER
