Page 4
The fridge has an automatic defrost cycle. Droplets
of condensation or ice particles on the back wall of
the fridge are normal.
When storing food in the fridge keep food away from
the rear wall. To allow free circulation of cold air
don’t pack food too tightly on the shelves and never
put hot food in the fridge.
Notes on operation
During normal operation the following noises may
be heard:
O
Stifled murmur from compressor when it is
working.
O
Soft gurgling from the refrigerant flowing
through the cooling system.
O
Click from the thermostat switching on and off.
Tilt and support the appliance then release the two
screws holding the bottom hinge plate to the corner
of the housing (Figure 4).
Lift away the door and place it safely on one side.
Unscrew the foot and refit it to the hole in the
opposite corner of the base of the housing
(Figure 5).
Return the appliance to the upright position.
Unscrew the pivot plate from the underside of the
cabinet top (Figure 6). Transfer the pivot plate to the
mounting holes in the opposite corner of the
underside of the cabinet top and fasten it in place
with the screws removed earlier.
Prise the blanking plug out of its hole in the top
edge of the door (Figure 7). Push the plug into the
hole in the opposite corner of the top edge of the
door.
Tilt and support the appliance.
Locate and support the door on the top pivot pin.
Take the bottom hinge plate (removed earlier).
Ensure the spacer is in place on the hinge pin, then
insert the hinge pin into the appropriate hole in the
bottom edge of the door.
Screw the hinge plate to the bottom corner of the
housing using the screws removed earlier.
Return the appliance to the upright position; door
reversal is now complete.
Door reversal
FIGURE 5
FIXED FOOT
FIGURE 6
PIVOT PLATE
SCREWS
PIVOT PIN
FIGURE 7
BLANKING PLUG
SPACER
ADJUSTABLE FOOT
FIGURE 4
BOTTOM
HINGE
PLATE
Reversing the door may make installation more convenient. The appliance must be tilted and
supported in order to carry this out; it is therefore advisable to get an assistant to help during this
procedure. Take care when fitting and tightening screws.
