Page 6
General cleaning
It is recommended to clean and wipe out the fridge
regularly or after any spillage inside or outside the
appliance.
Use a teaspoonful of bicarbonate of soda diluted in
a pint of warm water. Wipe the internal surfaces
and shelving to remove food residues. Leave to dry
before reloading food.
Beware of the back wall as this may be cold to the
touch. Avoid wiping this until it has thoroughly
defrosted.
Wipe the outside casing from time to time in order
to remove dirt and dust from ventilation vents etc.
Keep water away from the thermostat housing.
Clean the door seals.
Remove accumulated dirt from around the
compressor motor taking care not to damage the
pipes and the wiring.
Defrosting
It is recommended to regularly defrost the fridge
and frozen food compartment to ensure efficient
operation.
The frost on the internal surfaces must not exceed
6mm before defrosting.
Turn the temperature control to ‘0’.
Remove food from the fridge and frozen food
compartment keep the door open and wait until the
frost has melted. Do not use metal utensils to
remove frost.
When defrosted turn the temperature control to the
desired setting and replace the food.
Drainage channel
Water collects in the drainage channel on the back
wall. It then passes to a drip tray over the
compressor from which it evaporates. The drain
should be cleaned regularly to avoid the build up of
impurities. Wipe the channel with a damp cloth and
use a small bottle brush, pipe cleaner or similar
flexible object to clean out any residue from the
drainage hole.
FIGURE 11
DRAINAGE
HOLE
DRAINAGE
CHANNEL
Maintenance and cleaning
Important
The fridge must be turned off at the mains before maintenance or cleaning.
LIGHT
COVER
SCREW
LAMP
THERMOSTAT
HOUSING
FIGURE 12
Lamp replacement
To remove the light cover, remove the screw
(Figure 12) and gently slidie the cover outwards
away from the thermostat housing. Unscrew the
lamp and replace it with one of the same type, (15
watts SES E14). Replace the cover by reversing
the procedure.
