Louver setting when connected with 1-way panel.
4
1
Hold "Health" for over 3s to switch to
"1F" to control 1-way panel.
2
3
When the controller is
, press "3D/U. ." and
the icon is displa ed.
Press "3D/U. ." again and
the icon is displa ed,
indicating the louver is in
ultra far air suppl mode.
When the controller is ON,
press "Louver", and the
icon of up&down air supply
flashes. During flashing,
press to adjust
the location of louver.
The icon stops flashing
after 5s, and the louver is
at the set location.
When the controller is ON,
press "Louver", and the icon
of up&down air supply
flashes, then press "Louver"
again, the icon of left&right
air supply flashes. During
flashing, press to
adjust the location of louver.
The icon stops flashing after
5s, and the louver is at the
set location.
When the controller is ON,
press "3D/U.L." and the icon
is displayed, indicating
the louver is in 3D air supply
mode.
7
