P
5
Document 9850-000224-00 EG2
Connections
Connecting the Supply
Power is to be supplied to the EG2 via an external regulated power supply in
the range of 9-36VDC 0.3A
Cooper Controls are able to provide a recommended power supply if required.
Catalogue Number:
PSU-15-DIN
(15VDC 0.67A)
Wire gauge for supply terminals
Terminal sizes:
iCANnet
5 x 1.5mm²
iCAN Network Connections
A removable 5 way connector screw
terminal plug is provided for the
connection of iCAN network cables.
The recommended cable to use for
iCANnet is: CAT5 FTP.
-V
+V
Set Up Instructions
iCANnet
Connect the EG2 to the CAN network using the iCANnet connector. If the EG2 is at the
end of a network set the Term link to ON otherwise set to the OFF position.
Ethernet
Ethernet connection by RJ45 (568B). This should be connected to either an Ethernet Switch
or to a Wireless Router.
