ENGLISH
3
Call for customer service and/or missing or damaged parts (800-334-6871)
• Do not operate the unit with a missing or damaged wire safety guard, safety
glass lens (lamp containment) or UV filter.
• Do not direct the light at persons or look directly at lighted fixture.
• Use only with a 300 watt or smaller bulb. Installing a bulb of a higher
wattage could create a fire hazard. Use of a higher wattage bulb will void
the warranty.
• Never touch the bulb with your bare hands. Oil from your skin can cause
premature failure. Always handle the bulb with gloves or a soft cloth.
withple I
• If lens is replaced, use only a diffused tempered safety glass of
equal thickness.
• For maximum bulb life, position light so that the quartz halogen bulb remains
within 4 degree of horizontal.
• Disassembly of your fixture will void the warranty.
NOTE: When using outdoor use portable lamps, basic safety
precautions should always be followed to reduce the risk of fire,
electric shock and personal injury, including the following...
• Use only with three wire extension cords that have three-prong gorunding
plugs and that are suitable for outdoor use, such as cords marked SW, SW-A,
SOW, SOW-A, STW, STW-A, STOW, STOW-A, SJW, SJW-A, SJOW,
SJOW-A, SJTW-A, SJTOW, SJTOW-A and grounding receptacles that accept
a three-prong plug. When the fixture is used in wet locations, Ground Fault
Circuit Interruption (GFCI) protection must be provided on the circuit(s) or
outlet(s) to be used. Receptacles are available having built-in GFCI protection
and are able to be used for this measure of safety.
NOTE: Deviation from the assembly instructions may result in
a risk of fire or electric shock.
SAVE THESE INSTRUCTIONS.
Installing the bulb
Step 1:
Loosen the screw in the front of the handle located on top of
the fixture.
Step 2:
Open lens cover for easy access to the bulb.
Step 3:
Remove bulb and CAUTION sheet from housing. Unpack bulb, being
careful not to touch it with your bare hands (see caution sheet).
Step 4:
Using gloves or a soft cloth, gently press the bulb to one side of
the socket as indicated on the metal reflector and insert the opposite
end into the other side of the socket. Reverse this procedure to
remove the bulb.
Step 5:
Close the lens cover and tighten the screw.
Note:
Should the light not turn on when power is applied, unplug the unit,
then check that the bulb is properly seated in the sockets.
Spare Bulb:
A spare 300 watt halogen bulb is located in the bulb storage
compartment located below and behind the switch/receptacle box. Remove the
cap at the end of the storage compartment to access the bulb. Always handle
the bulb with gloves or a soft cloth.
PHL300 325-1576.qxd 8/22/06 4:13 PM Page 3
