Call for customer service and/or missing or damaged parts (800-334-6871)
3
• Do not operate the portable luminaire with a missing or damaged guard, lamp
containment barrier (lens) or UV filter.
• If lens is replaced, use only a diffused tempered safety glass of equal thickness.
• Use of bulb(s) of higher wattage rating than what is listed in the safety instructions
will void the warranty.
• Dissassembly of the fixture will void the warranty.
• Fixture must be connected to a 120 Volt, 60 Hz power source. Any other
connection voids warranty.
• The electrical system, and the method of electrically connecting the fixture to it,
must be in accordance with the National Electrical Code and local building codes.
• For indoor and outdoor use.
• cULus Listed.
WARNING: When using outdoor use portable luminaires, basic safety
precautions should always be followed to reduce the risk of fire, electric
shock, and personal injury, incuding the following:
Read all instructions.
• Use only three-wire outdoor extension cords that have three-prong grounding plugs
and grounding recptacles that accept the applianceʼs plug.
• Ground Fault Circuit Interrupter (GFCI) protection is to be provided on the circuit(s)
or outlet(s) to be used for the wet location portable luminaire. Receptacles are
available having built-in GFCI protection and are able to be used for this measure
of safety.
• Use only with an extrension cord for outdoor use, such as an extension cord of
cord type SW, SW-A, SOW, SOW-A, STW, STW-A, STOW, STOW-A, SJW, SJW-A,
SJOW, SJOW-A, SJTW, SJTW-A, SJTOW, SJTOW-A.
SAVE THESE INSTRUCTIONS.
ASSEMBLING YOUR FIXTURE
WARNING: Deviation from the assembly instructions may result in a
risk of fire or electric shock.
1.
Attach light head (A) and handle (E) to the light
bracket (F). This step will require using the
(2) long bolts, (2) lock washers, (2) spacers,
(4) regular washers and (2) light head knobs
(Fig. 1).
2.
Attach the light bracket (F) to the stand (D) using (2) short bolts.
3.
Attach handle to light fixture using 4 screws.
4.
Install the grille guard (C) in the light fixture by inserting one side of the guard
between the frame and the lens. Squeeze the guard until the other side can be
placed between the opposite side of the frame and lens.
Fig. 1
All manuals and user guides at all-guides.com
