User Manual: WaveLinx Lite (1.5)
www.cooperlighting.com
11
Line Voltage Wallstation Reference Sheet
Line Voltage Wallstation
Features
•
Bluetooth 4.2 Low Energy
transmitter
•
Commands Supported:
•
Scene selection
•
Raise/lower
•
Zone level
•
Area OFF
•
No Action
Typical Applications
Education and office spaces, other
interior spaces
Models:
WWWL3
: 3 Button (WWL3)
WWL3-RL
: 3 Button with Raise/Lower
WWL5-RL
: 5 Button with Raise/Lower
Custom engraving options
Device Type in Mobile App:
Wallstation
Powered from line voltage (120-277VAC), the WaveLinx Line Voltage Wallstation can be
installed in single or multi-gang configurations. The WaveLinx Line Voltage Wallstation controls
WaveLinx Lite devices by sending control signals through the Bluetooth Mesh network.
Out-of-the-Box Operation
•
The wallstation will not control lighting out-of-the-box until it has been provisioned.
•
When a button is pressed, the wallstation LED will blink GREEN (ON for 1 second, OFF for 1
second) for 10 seconds and then turn OFF to indicate that the wallstation is powered and in
out-of-the-box mode.
Provisioned Device Default Behavior
Once provisioned in the WaveLinx Lite Mobile App, the Line Voltage Wallstation operates
lighting assigned to the same area per the default programming. The LED at the top of the
wallstation will turn ON for 3 seconds when a button is pressed.
Button
Function
1
Scene 3: 50%
2
Scene 1: 100%
3
(WWL5-RL only)
Scene 2: 70%
4
(WWL5-RL only)
Scene 4: 30%
Press: increase 1% (per press)
1
Hold: increase 15% (per second)
1
Press: decrease 1% (per press)
1
Hold: decrease 15% (per second)
1
Scene 0: OFF
1
1
Note:
This command affects all zones in the area.
LED Behavior
The LED is located above the top button on the wallstation.
LED conditions
Meaning
Flashes green (ON for 1 sec.
OFF for 1 sec.) for 10 seconds
A button was pressed and the wallstation is not provisioned
Flashes (ON for 1 sec. OFF for 1
sec.) for 15 seconds
The mobile application has been used to place the wallstation
into Identification Mode. The LED will be green on an
unprovisioned wallstation and white on a provisioned
wallstation.
Turns ON white for 3 seconds A button was pressed on the provisioned wallstation
LED flashes yellow
The wallstation is being factory reset using the onboard reset.
LED is OFF
The LED will be OFF during normal conditions when buttons are
not being pressed if the station is powered
LED
location