CEAG Notlichtsysteme GmbH
7
Assembly and Operating Instructions
Automatic Test System AT-S
+
with STAR
+
Technology
Important Notes
2.2 Contents of Operating Instructions
Every person, ordered to work with the system, has to read the instructions carefully to understand them before
work begins. This takes also place when the person has already worked with a similar kind of system or was in-
structed by the manufacturer.
2.3 Changes and Modifications to the System
To avoid danger and to assure optimum performance, changes and modifications to the system are not allowed,
except when the manufacturer has approved them.
Any work involved in extensions, conversions or repairs and which is not described in this manual must be carried
out by specially trained technical and service personnel (of the manufacturer CEAG or of CEAG-authorised distri-
bution and service contractors)!
2.4 Responsibility of the Operator
Keep the instructions near to the system, accessible for every person working with the system and at all times.
The System must be in a proper and safe condition when using it. System has to be checked for intactness before
using it.
Adhere to the information of the instructions completely!
2.5 Personnel Requirements
Only authorised and skilled personnel are allowed to work on and with the system. The personnel must have re-
ceived instructions regarding the existing danger.
Skilled personnel refers to those with expert training, with knowledge and experience as well as knowledge of the
relevant regulations. He should be able to evaluate his work and recognize the presence of danger.
Personnel without the necessary knowledge must
r
have received qualified and proper training,
r
get their tasks and activities by full description for complete understanding
r
carry out the activities under the supervision and control of skilled and qualified personnel.
2.6 Operational Safety
Observing the stated safety instructions and regulations can avoid damage to property and people when working
with the system.
However the following organisational measurements must be specified in writing and be kept:
r
Duties of information and reporting (start, duration, end of the work)
r
Safety measures while the work is being carried out: e. g. standby lighting, power supply isolation and lock-
out (e. g. removing the fuses, key-operated switch, safety signage)
r
Safety equipment for the personnel carrying out the work on the plant (s. chapter 2.7)
r
Safety equipment providing protection from hazards caused by adjacent plant (e. g. safety grilles, barriers,
making safe of roads)
Attend to the ESD-protection during working at the system!
The applicable work and safety regulations are set out in these assembly and operating instructions, and in
r
the management´s internal organisational instructions (example see above)
r
and the general and specialist technical guidelines and accident prevention regulations.
2.7 Personal Protective Equipment
When working on and with the system it is necessary to wear:
r
Protective Clothes
Close fitting protective clothes (low tensile strength, no wide arms,
no rings and further jewelry, etc).
r
Safety Boots
Boots electrostatic conductive acc. to EN 345
and to protect against heavy falling parts.
Summary of Contents for Ceag AT-S+ C0
Page 76: ...400 71 860 177 XXX 07 12 WK...
