MCC STROBE CANDELA SELECTION:
Figure 1A: MCC
Figure 1B: MCCH
95
CANDELA
POINTER
BOTTOM VIEW
30
15
75
177
CANDELA
POINTER
BOTTOM VIEW
115
NOTE:
The strobe candela selector is pre-set at 15cd for MCC and 177cd for MCCH strobes. To change the strobe candela move selector switch, insert screwdriver
into slot shown on the bottom side of the strobe. The setting is indicated by a pointer and can be seen on the bottom side of the lens. See Figures 1A and 1B.
WIRING AND MOUNTING INFORMATION:
CAUTION:
The following figures show the maximum number of field wires (conductors) that can enter the backbox used with each mounting option. If these
limits are exceeded, there may be insufficient space in the backbox to accommodate the field wires and stresses from the wires could damage the product.
Although the limits shown for each mounting option comply with the National Electrical Code (NEC), Cooper Wheelock recommends use of the largest backbox option
shown and the use of approved stranded field wires, whenever possible, to provide additional wiring room for easy installation and minimum stress on the product from
wiring.
FLUSH MOUNTING
STD. SINGLE-GANG
BACKBOX 2" DEEP
#6-32 SCREWS
STROBE MOUNTING
PLATE
BEAUTY PLATE
A
MAXIMUM NUMBER OF CONDUCTORS
AWG #18 AWG #16 AWG #14 AWG # 12
4 4 4 4
B
FLUSH OR SURFACE MOUNT
4" SQ. X 1-1/2" DEEP BACKBOX
OR 100mm X 37.5mm
EUROPEAN BACKBOX
STROBE MOUNTING
PLATE
#8-32 SCREWS
BEAUTY PLATE
MAXIMUM NUMBER OF CONDUCTORS
AWG #18 AWG #16 AWG #14 AWG # 12
4 4 4 4
#6-32 SCREWS
MAXIMUM NUMBER OF CONDUCTORS
AWG #18 AWG #16 AWG #14 AWG #12
4 4 4 4
STROBE MOUNTING
PLATE
BEAUTY PLATE
DOUBLE-GANG X 2-1/4"
DEEP BACKBOX
FLUSH OR SURFACE MOUNT
C
SURFACE MOUNTING
SHALLOW SURFACE
BACKBOX SHBB
STROBE MOUNTING
#8-32 SCREWS
D
PLATE
BEAUTY PLATE
MAXIMUM NUMBER OF CONDUCTORS
AWG #18 AWG #16 AWG #14 AWG # 12
4 4 4 4
P84517 L
Sheet 2 of 4
