Mounting the TSE55-B
Align the mounting frame hooks with the
TSE55-B mounting slots and gently push the
TSE55-B unit onto the mounting bracket.
Make sure the mounting hooks are properly
engaged.
Tighten the 2 captive screws (one at each
side) to secure the TSE55-B to the mounting
bracket.
Power connection
TSE55-B is designed to be powered over the
Ethernet connection (PoE).
PoE Connection
PoE connection requires that IEEE 802.3af
standard. Utilize a network switch or PoE injector
that meets this standard.
Connect the TSE55-B using a standard CAT5E or
CAT6 Ethernet cable from the network switch to
the LAN/PoE jack on the back of the TSE55-B.
Connecting Ethernet
When not utilizing a PoE switch, it is recommended
that you connect the TSE55-B to a network switch
via a PoE injector.
Utilizing a standard CAT5E or CAT6 network
Ethernet cable connect to the LAN/PoE jack.
Connecting to the lighting
network
TSE55-B connects to the lighting network using a
touchscreen interface (TSI-1 or TSI-1NA). Ensure
that both the touchscreen and touchscreen
interface are on the same physical Ethernet
Network and within the same IP address range.
See the TSE User Guide for information on setting
IP addresses.
Source
Controller
Control Plate /
Wallstation
iCAN
Ethernet
Switch
PoE
TSI-1 /
TSI1-NA
TSE
Touchscreen
