Typical connection diagram
L N
Incoming Supply
120 - 277V AC
Mains supply protection:
Provided by installer (6A Type C MCB recommended)
LED
Lamps
Device Identification
Button
Manual Control
Buttons
DALI
Input
Alarm Input
(volt free)
iCAN Network
Termination
*
This unit does not V to the iCAN network. Requires 85mA @ 15V DC
either via pre-powered iCAN network or from external PSU
Connection
to the iCAN
Network*
IMPORTANT NOTE:
Connecting a mains potential cable to the
iCAN Network terminals is likley to damage the unit and other
devices connected, and invalidate warranty.
Cooper Lighting Solutions
1121 Highway 74 South
Peachtree City, GA 30269
P: 770-486-4800
www.cooperlighting.com
For service or technical assistance:
1-800-553-3879
Canada Sales
5925 McLaughlin Road
Mississauga, Ontario L5R 1B8
P: 905-501-3000
F: 905-501-3172
© 2022 Cooper Lighting Solutions
All Rights Reserved.
Product availability, specifications,
and compliances are subject to
change without notice.
IL Area Controller with SCMA0401 Adaptive Dimmer
WaveLinx Wired
IB50301922 page 7
March 2022
Device LEDs and buttons
Status LED
Green LED flashes – device OK
Green LED flashes rapidly - device under DALI control
Data LED
Red LED flashes when messages sent on network
Red LED solid indicates iCANnet network error
Alarm LED
Red LED flashes ON for local initiated alarm
Red LED solid for network initiated alarm
Device Identification
Press and release switch.
Sending a message to identify the device on the network
(red Data LED flashes)
Channel Output Status LEDs
LEDs turn on when the channel is > 0%
LEDs turn off when the channel is 0%
Manual Control of Channel Outputs
By holding the IDENT button down for 5 seconds, manual control of each
channel is enabled using the UP and DOWN buttons.
A short press of the UP button will raise the output level by 10% on each
press. A long press (>1s) of the UP button will set the output level to
100%. The same operation is true for the DOWN but in reverse.
Press the IDENT button to change the output channel being controlled.
To exit manual control hold the IDENT button down for 5 seconds.
Warranties and Limitation of Liability
Please refer to www.cooperlighting.com for our terms and conditions.
