4L Instant Water Boiler
10377
Instructions for Use
Please read and retain these instructions for future reference
v008:02/01/19
Page No. 4
DO NOT leave the water boiler unattended to avoid risk of overfilling and spillage.
If you want to obtain water again, repeat the above procedure.
Remarks
Do not touch the boiled water and steam in order to protect against scalding by boiled water and hot
steam.
Safety cut-out: If the appliance stops operating with beep sound and the PCB panel show E7 symbols
then, there is insufficient water. Please fill the water tank below max level.
The appliance can memorize the last operation method until the plug is disconnected.
As the appliance has memory function when powered on please use about 60 seconds first in order
to obtain desired temperature water. When switched off the memory will reset.
As ambient temperature can change every day, the water volume dispensed can fluctuate within
-15% to +15%, please take care and press the Confirm button to stop the appliance to avoid
overfilling.
This appliance has manual thermostat to recover the heating function should the appliance stop
functioning, you can reset the thermostat by a
reset key.
After cleaning the appliance, please open the drainage stopper in order to clean away the wastewater.
Note: Tighten the drainage stopper once water has drained and before reuse.
