Slide Scanner
9366
Instructions
Please read carefully before use and retain for future reference.
BEFORE USE
The brush can be used to clean the backlight panel.
Place the slide scanner on the side and insert the end of the brush into the door
on the right side.
Clean the backlight panel placed in the slide scanner.
FILM HOLDER
The film holder will hold ISO standard films. In some cases the holes on the film
may not match exactly with the alignment of the holder. This is caused by a non-
ISO standard camera. In this case, there will be a small black line on the edge of
the frame that can easily be cropped out using photo editing software.
LOADING SLIDES
1. Hold up the slide toward the light. Face
the trademark side of the slide away from
you. Look through the slide and it should
appear normally (not a mirror image).
Now turn the slide so the image is upside
down while looking at the same side.
2. Open the slide holder by releasing the clip
in the centre. With the slide holder laid
open, place the slide into recessed area in
the holder.
Handle slides with care. Any scratches, finger prints or dust will show up on the
saved images. If possible, use cotton gloves when handling slides. It is
recommended to use compressed air (not supplied) to remove any dust on the
slides.
3. Close the slide holder and press the edges
so that it locks in place.
4. Hold it in the position as showing the slide
scanner. Insert the slide scanner into the
slot on the right side of the slide scanner
as shown.
LOADING NEGATIVES
1. Hold up the negative toward the light. As
you look through the negative, you should
be able to read the small negative numbers
normally (not a mirror image). Now turn the
negative so the image is upside down while
looking at the same side.
2. Open the negative holder by releasing the
clip in the centre. With the negative holder
laid open place the negative into holder so
the notches line up with the notches on the
holder.
Note: Handle negatives with care. Any dust,
scratches or finger prints will show up on your saved images. If possible use
cotton gloves when handling negatives. It is recommended to use compressed air
to remove any dust on the negatives.
This is not included with the slide scanner but can be purchased from an office
supply or electronics retailer.
3. Close the negative holder and press the
edges so that it locks in place.
4. Hold it in the position as shown in the slide
scanner. Insert the negative holder into the
slot on the right side of the slide scanner as
shown.
OPERATION
1. Insert SD card into SD card socket with the metal connector strips facing
upwards.
Note: The Slide Scanner must have an SD card fitted to scan images.
2. Insert the negative or positive film holder into the slide scanner.
3. Connect UK plug adaptor to the USB cable and plug into the mains.
4. Press the power button to turn on the slide scanner.
Note: When the slide scanner is turned on it will automatically enter the shooting
mode.
5. To change the language, use the
arrow buttons when in the main
menu screen and select ‘Language’
and then press SCAN OK button.
Use the arrow buttons to select the
desired language and confirm by
pressing the ‘Scan OK’ button.
Choose from: English, French, German,
Italian, Spanish, Traditional Chinese,
Simplified Chinese, Japanese.
PARTS
Slide scanner
GB SD card
UK plug
adaptor
Negative film
holder
Positive slide
holder
Brush
USB cable
AV cable
2
