软件使用方式与 N100 一致,如下:
The usage mode of the software is the same as that of N100, as
follows:
A:线性控制(默认开启)
A:Linear control (on by default)
线性控制是用来关闭或开启手柄摇杆和扳机的线性响应,以实现更短的键程和更快的响应速
度
Linear control is used to turn off or turn on the linear response of the handle rocker
and trigger to achieve a shorter bond range and faster response speed.
1.
关闭线性
1.
Turn off the linear
A. 同时按下 HOME+下键并松开,进入线性控制功能配置模式
A. Press the HOME+ Down button at the same time and release to enter the linear
control function configuration mode.
B. 将需要关闭线性功能的扳机按住不放,或拨动需要关闭线性功能的摇杆,再按一下中左
键,即可关闭对应扳机或摇杆的线性功能
B. Press the trigger that need to turn off the linear function, or dial the rocker that
need to turn off the linear function, and then click the Middle left button to turn off
the linear function of the corresponding trigger or rocker.
C. 按一下 HOME 键,退出配置模式
C. Press the HOME button to exit the configuration mode.