5. 调整连发频率(自定义模式)
5. Adjust the burst frequency(Custom mode)
(Firmware version not less than V4.1001)
In custom mode, the user can set two parameters: press time a millisecond and
release time b milliseconds. When the burst starts, the key is automatically pressed
for a millisecond, then released for b milliseconds, and then pressed a millisecond
for a round trip. The values of a and b should be greater than 4 and less than 252.
A. Determine the value you want to set, such as a is 128, b is 164
B. Press the HOME + function button at the same time left and release, enter the
serial configuration mode
C. Hold down the middle left button and right button, and do not release
D. set a value: press the function key, the value of a increase of 100; press the right
two function keys, a value increased by 20; press the eight function keys, a value
increased by 8. Total 128
E. Set the b value: Press the cross key, the value of b increases by 100; press the six
lower cross key right, the b value increases by 60; press the four lower cross key, the
b value increases by 4. Total 164
F. release the middle and left and right button, the normal configuration, it will flash
green light.
G. If there is a configuration error during step 2 through step 6, you can reconfigure