N100 Pro 有线连接示意图:
N100 Pro wired connection diagram:
连接设备(如连接示意图所示)
Connect the device (as shown in the connection diagram)
将 TYPEC OTG 线插入 SWITCH 充电口,COOV N100 Pro 插入此 TYPEC 线末端。手
柄通过手柄数据线连入 COOV N100 末端即可正常工作。
Insert the TYPEC OTG cable into the SWITCH charging port and insert COOV N100
Pro at the end of this TYPEC line. The handle is connected to the end of the COOV
N100 through the handle data cable to work normally.