4
Function Instruction
This passage mainly describes the main function and general principle of integrative speed dome, and
does not refer to the concrete operation methods. Different system platform has different operation methods,
generally, we should according to the system manufactory's operation manual. Please contact dealer to get
necessary information, under some conditions there are have some particular requirements and operations.
and Sw2 is for setting communication baud
rate and controlling protocol. (For detail setting, please refer to 9.7 DIP switch setting)
Except the factory protocol(FACTORY), the speed dome is compatible with various popular protocols, such
as PECLO-D
PECLO-P
ERNITEC
VCL
MOLYNX
VICON
SANTACHI
PANASONIC
SAMUNG
DIAMOND
KALATEL
LILIN
PHILIPS
VIDO B02
AD and so on.
Any controlling command must base on the objective camera address, and the camera only answer to the
controlling command the address which coincide with itself. There are three kinds of camera address:
When manually adjusting, for far focus situation, the dome responds at a high-speed so that touching
rocker slightly may make picture move rapidly, thus cause the picture to lose. To base on humanized design,
the dome automatically adjust pan and tilt rotation according to zoom near and far, which make it is
convenient to operate manually to make tracks for the object. In the menu, you may change system
parameter setting pro portion pan as ON, thus you may run this function.
If user holds the joystick in the down position, the camera rotates pan 180 degrees,
he camera
rotates tilts up to 90 degrees, you may directly watch the rear view
ocesses in
portrait 180 degrees . In the menu, you may set the system parameter setting AUTO FLIP as ON, thus you
may run this function.
By the menu
park time
and
park action
, user may set auto-call preset or run tour, pattern, and
scan, etc after pointing a few minutes if the dome doesn't run any motions.
By the menu
power up action
, after the dome powers up or restarts, user may set auto- resume
movements before power up and auto- call preset or run tour, pattern, and scan etc .
Camera ID
Auto-run motion
Auto flip
Power up action
、
、
、
、
、
、
、
、
、
、
、
、
、
、
Use camera's switch number to set address 1-8 bits, the address rang e is 1-254.
Broadcast address:(Only factory protoco l and Pelco can be set) If user chooses broadcast address to
control, all the cameras connected with the control system will react to the same commands. When set as
factory protocol, the broadcast address is 255.
Debug address: (Only factory protocol and PELCO can be set) if camera ID is set 0, user may select
any address to control the dome.
3.1
3.2
Park action
There are two 8-b it switch sw1 and sw2 on the commutator,
●
●
●
Common address:
Ø
Ø
Ø
Ø
Focus/speed proportion pan
“
”
“
”
“
”
then t
to realize surveillance all pr
3. Function Instruction
PDF created with pdfFactory Pro trial version
www.pdffactory.com
