26
¾
ᇹ
Enable Auto Snapshot
ᇺ
When the motion events happened, system will send alarm JPG image
to all connected clients automatically.
¾
ᇹ
Alarm Time Set
ᇺ
For specific time that motion events need to be detected, input the time setting
value according to your conditions.
¾
ᇹ
Linkage Alarm Out
ᇺ
System provides 2 channels on-off camera outputs for user to connect
with bells, lights, beepers etc. When motion event happens, system will output on-off value to
attached devices.
¾
ᇹ
Alarm Clear Time
ᇺ
alarm cancellation time. The alarm output will be canceled after this time
¾
ᇹ
Alarm area
ᇺ
To set the image dynamic detection zone (each channel of image is divided into a
matrix with 9 rows and 11 lines. There are 99 zones can be set), zones out of set zones will not
perform the dynamic detection tas
k
. Red zones mean “they are image dynamic detection zones”.
You can draw the zones with mouse.
¾
ᇹ
Sensitive
ᇺ
The sensitivity of motion detection, 1 is the highest value.
Setting skill
1
᧪
You can set the detection sensitivity as a higher value to avoid the false alarm causing by small
object motions.
2
᧪
You can set sensitivity as a higher value to avoid the frequent alarm at environment where object
motions frequently happen.
3
᧪
Only extreme accurate motion alarm settings need lower sensitivity value. High sensitivity value is
recommended for all other situations.
3.6.2. Video loss alarm management
After the video loss alarm function is enabled, when the video loss happened, the video server will
perform the sensor combined output operation and send alarm message to client. Client will deal with
the alarm according to the local setting. Video loss alarm information including server name, IP, alarm
type, and time will be saved into log for future inquiry.
Video loss alarm setting
It is shown as following figure:
