Basic Operation
2
Figure 3
.
Controller diagram
Desk Height Display (inches or cm)
Digital Controller Operation
Basic operation
Press and hold to raise desk height
Press and hold to lower desk height
First Memory Preset Key
– press and hold key
to save current position
Second Memory Preset Key
– press and hold
key to save current position
Third Memory Preset Key
– press and hold
key to save current position
Function Key
Memory Presets
o
Press and
hold the ‘^’ or ‘˅’ key
to desired height positions.
o
Press and hold the
‘1’, ‘2’, or ‘3’ key
(approximately 3 seconds) to set the memory
position.
Reset
The reset procedure must be completed prior to initial use, after parts have been replaced or
in certain troubleshooting situations.
o
Press and hold the
‘^’ and ‘v’ keys simultaneously (for approximately 5 seconds).
Legs will begin to move down at half of normal speed, controller will indicate
‘000’ on the
screen and controller will beep.
o
Keep holding
‘^’ and ‘v’ keys
until legs reach the lowest position, rebound 2-5mm, then
stop.
o
Release ‘^’ and ‘v’ keys to complete initialization.
