Tools required
Allen wrench
3
Figure 3
.
initial re-alignment
Extension table re-alignment tips
N
o t e
Your table was checked for proper alignment before it was packed for shipment.
During shipment this alignment may have been impacted. If this occurred it may
require some adjustment.
Tips:
Re-aligning extension table
When the leaf is in the open
position loosen the bolts attaching
the table to the base.
Tighten the bolts working in a “X”
pattern.
Align the leaf and table ends.
1.
2.
3.
Loosen the
bolts before
re-alignment.
Tighten the
bolts after
alignment .
1.
3.
With the leaf is in the open position loosen all the
screws attaching the metal slides to the table tops.
Tighten the screws.
Align the leaf and table ends.
1.
2.
3.
Philips head screw driver
If the above method proves
insufficient the table tops have
moved on the slides themselves.
To correct this (Figure 4):
Loosen the
screws before
re-alignment.
Tighten the
screws after
alignment .
1.
3.
Figure 4
.
further re-alignment
(Figure 3)
Attention
After the table is fully assembled, DO NOT try to pick up the table from the ends
–
especially if the table is fully extended. Should the table need to be relocated, close the
table and carefully lift the table in the middle area where the two tops meet.
