2C9-1
1-3-10
Maintenance mode 070 (sub-scan line adjustment)
For copy example a: decrease the value.
For copy example b: increase the value.
Changing the value by one changes the sub-scan line by 0.1%.
The larger the value, the larger the magnification of the sub-scan line of the copy image.
The smaller the value, the smaller the magnification of the sub-scan line of the copy image.
Figure 1-3-16
Maintenance mode 071 (leading edge timing adjustment)
For copy example a: increase the value.
For copy example b: decrease the value.
Changing the value by one moves the leading edge by 0.17 mm.
The larger the value, the later the image scan start timing.
The smaller the value, the earlier the image scan start timing.
Figure 1-3-17
Maintenance mode 072 (center line adjustment)
For copy example a: increase the value.
For copy example b: decrease the value.
Changing the value by one moves the center line by 0.17 mm.
The larger the value, the center of the image moves toward the right.
The smaller the value, the center of the image moves toward the left.
Figure 1-3-18
Original
Copy example a
Copy example b
Original
Copy example a
Copy example b
Original
Copy example a
Copy example b
Summary of Contents for CS-1620
