- 23 -
Section 3: Print copies of your LightScribe label with the LightScribe Label CD
you’ve created.
Step
1:
Use the up or down arrow button to navigate to the Print menu:
Step
2:
Press the “ENT”/Enter button to enter the Print menu. You should then see the
Counter feature screen.
The Counter feature will let you choose how many copies you want to print for your project.
It allows the system to count the number of copies you’ve made and prompt you when the
desired number of copies has been made for this job.
The Counter feature is for your convenience only, and will allow you to make
more copies than the previously desired amount, if so required.
You can choose not to input your desired number of copies if you prefer to print continuously
with no interruption. (It will still count the number of copies you’ve made for this job, but it will
not notify you when to stop.) To do so, simply press “ENT”/Enter button when you see the
“No Counter” on the 2
nd
line of the screen below:
Or, you can choose to enter the desired number of copies for this job by following the simple
procedure below:
a) Press the up or down button to the following screen:
b) Then press the “ENT”/Enter button to submit, and you should see the following
Specify Counter screen:
c) Please refer to the “Input Name and Number” section of “Chapter 2: Getting to know
your System” to enter the desired amount. Then press “ENT”/Enter to continue next
step.
DUPLICATOR 2.20
2.Print
Counter:
No Counter
Counter:
No Counter
Counter:
Specify Counter
Specify Counter:
[ ] OK?
