Reverse Nano Pump User’s Manual
Ⅰ. Introduction
CoralBox wave makers are specifically engineered as the perfect equipment to simulate the
natural sea environments.
RN-1 pump is a very compact propeller pump using innovation and high technology
solutions to provide natural environments for different sea inhabitants in aquariums,fish
tanks or in ponds.
The excellent design,including the compact housing and the magnet holder,permits 3D flow
directions and simple mounting at every point of aquarium walls.
Before assembling and operating correctly, please read the user manual carefully.
Ⅱ. Function Overview
1.
Unique control system allows to operate with different types of wave and multiple
functions,which can generate different wave patterns according to different needs.
2.
Wireless controllers allow to synchronize operation among wave makers.One main
controller can remotely control several sub-controllers.
3.
Low voltage DC electronic pump with variable frequency provides a safe environment
for users.
4.
Easy operation to achieve the multiple sea moving patterns.
5.
Flow direction can be adjusted by different operative modes,as needed.
6.
Large range of voltage input (AC100~240V 50/60Hz) allows to operate in various
power systems and prevent the impact on waves shapes.
Ⅲ.Package Content
Ⅳ.Assembly and installation Notes
Suitable for most sizes of fish tans and ponds,up to 15mm glass wall thickness.
Caution!Danger of injury!Pay attention to your fingers when locating the magnet due to the
strong attractive power.
1.
Separate the external magnet from the pump package. Locate the pump in the selected
position inside the tank on the internal side of the glass wall. Locate the external magnet on
the external side of the same glass wall and slide it up to the pump position. Ensure that the
aquarium glass is free form algae inside and is dry and clean outside.
2.
If the controller has to be stuck on the tank, peel-off the protection paper from one side of
the double sided tape and past it on the back side of the controller. Peel-off the second
protection paper and locate the controller in the selected position.
3.
Connect the pump to the controller by means of the 3-pins connector. Insert the adapter
plug to the controller and connect the power unit to the power supply source.
4.
Start controller programming.
Ⅴ.Operation and Function
1.Buttons and Functions of LED Display Controller
Mode/Night
:
Press the button to select different
modes:F1,F2,F3,F4,F5,F6 F7and enter to the Night
mode by long hold-down the button.
Freq/reverse
:
Press the button to adjust the
Frequency and long hold the button to enter in the
Reverse mode.
WI-LE/Reset
:
Press the button to select Master
control ”M”,"S" for Slave,”N” for Standalone unit. Hold
down the Reset key for 3 sec. to reset the controller unit.
Arrow keys :
10Mins Feed / 20Mins Feed or move position.
*Attention:
If the pump operates in Night Mode,any other mode/feeding is disabled until exit
from the Night Mode
Be careful: Make sure to switch off the main controller before plug it with DC power supply
or plug with powerhead block.
Coral Box wave maker pump
Wireless controller with connection cable
Power unit with power cable
Bi-adhesive
User manual
Name
RN1
Operating
Tension
24V
Flow Rate
1500~10000L
(396~2642gal/h)
Cable Length
1860mm (73inch)
Energy
Consumption
25W
Dimension
78*72* 52mm
(3.1*2.8*2 inch)
Voltage /
Frequency
110/240V 20/60Hz
Outlet Nozzle
diameter
70mm (2.8inch)
