SILICONE
OIL
50%
WAIT
TIGHTEN
TIGHTEN
FULLY
5min
FILL
MOVE
UP
3-4x
SLOWL
Y
MOVE
UP
FRONT
REAR
SILICONE OIL
SPRING TENSION
SILICONE OIL
SPRING TENSION
SHOCK PISTON
TRACK USE
450CPS
4mm
400CPS
0mm
6 Holes Ø1.3mm
OFF-ROAD
550CPS
4mm
450CPS
0mm
6 Holes Ø1.3mm
BASHING
600CPS
4mm
500CPS
0mm
6 Holes Ø1.3mm
FACTORY
500CPS
4mm
400CPS
0mm
6 Holes Ø1.3mm
SPRING TENSION
10
SHOCK ABSORBER MAINTENANCE
Remove the shock absorbers from the car. (4x)
Remove the shock cap.
Drain the oil from the shock absorber.
It may be necessary to replace the silicone oil in the shock absorbers every 40 runs.
It depends on how you drive and the type of terrain you drive on.
FILL THE SHOCK ABSORBERS WITH NEW SILICONE OIL
ALWAYS USE SILICONE OIL, NEVER USE ANY OTHER TYPES OF OIL.
.
www. corally.com/Chemicals/Silicone-Oils/
• Pull the Shock shaft
down.
• Fill the shock body with
silicone oil.
• Front : 450cps
Rear : 400cps
• Move the piston up&down
(3-4x) to release the air
bubbles in the silicone
oil.
• Pull the Shock shaft
down.
• Install the shock absorb-
er vertically and let it sit
for a few minutes until
the bubbles rise to the
surface.
• Install the silicone mem-
brane in the shock cap.
• Tighten slightly the
shock cap on the shock
body.
• A little oil will flow out of
the shock absorber.
• Gently move the piston
in upper position.
• The excess will flow out
of the shock absorber.
• Allow the piston in the
upper position.
• Tighten the cap fully but
not too much otherwise
the membrane will be
deformed.
Summary of Contents for RADIX XP 6S
Page 27: ...27 ...
