4
INLINE WITH SIDE PANEL
INLINE ONLY
Only fit the wall
bracket in the
position shown
(plan view of the
enclosure).
Only fit the wall
bracket/s in the
position/s shown
(plan view of the
enclosure).
a:
Insert both 'pivot brackets' (PN80499 & PN80524) onto the strut tube (PN10937).
Note:
The strut tube may need trimming to length to suit your requirements.
b:
Tighten both 'pivot bracket' grub screws onto the strut tube.
IMPORTANT:
Ensure the pivot brackets 'pivot' horizontally.
c:
Position the strut assembly onto the panel and against the wall.
d:
Ensure the strut is level and mark the position of the wall pivot onto the wall. Remove the strut from the panel.
3
a
c
b
d
a:
Remove the wall pivot from the strut.
b:
Unscrew and remove the wall bracket from the end of the wall pivot.
c:
Drill a 6.5mm hole 30mm deep in the middle of the position marked on the wall.
d:
Push fit a wall plug and attach the wall bracket to the wall using a 32mm screw.
e:
Screw the wall pivot onto the wall bracket.
IMPORTANT:
The wall pivot
MUST
pivot horizontally, if it does not, loosen and slightly rotate the wall
bracket refit the wall pivot and check again.
4
a
b
c
d
e
32mm
ø 6.5
mm
PN80524
PN80499
PN10937
PN80499
Wall bracket
