11
a:
Place the bottom rail onto the tray with its end mouldings inserted into the corner post and wall channel.
b:
Centre the bottom rail between the corner post and wall channel so that there is an equal gap at each end.
a
=
=
b
6
Push fit the 'short flipper seals' onto the top and bottom
edges of the fixed panels - flush against the metal profile.
Ensure the flipper seal 'flaps' are on the inside of the
fixed panels.
Note:
Wetting the glass with water will help to fit the seals.
7
Position the fixed panels into the corner post and wall
channel and slide down so they fully slot onto the end
mouldings of the bottom rail. Inside the enclosure, ensure the
panels sits in the 'fixed panel brackets', slide the brackets
along the rail and position under the panels as shown.
Fixed
panel
bracket
Outside
face of
fixed
panel
Outside
face of fixed
panels
Outside
face of
fixed
panel
5
