plastic bag.
take down part and put it back into the
and then disconnect electrical connector.
2.Open part on top of the upper door
left ref
door stop,
left ref
cover
left upper hinge door stop,
Parts you will need
REVERSING THE DOOR
2
1
3
2
1
3
2
1
bag.
part detached back into the plastic
bag) to the left side with screws . Put
part and another part (in the plastic
p a r t a n d p a r t t h e n i n s t a l l
upwards. Loose screws , detach
on a smooth surface with its panel
4. Remove the upper door and place it
during step 2 to prevent the door from
dropping.
Note: Please hold the upper door by hand
screws and put them back into the plastic
bag.
3.Remove part , then remove the
2
1
The side on which the door opens can be
changed, from the right side (as
supplied) to the left side, if needed for
the installation site.
Warning! When reversing the door, the
appliance must not be connected to the
main. Ensure that the plug is removed
from the main socket.
Tools you will need
Note: Before you start, lay the
refrigerator on its back in order to gain
access to the base, you should rest it on
soft foam packaging or similar material
to avoid damaging the backboard of the
refrigerator. To reverse the door, the
following steps are generally
recommended
:
1. Stand the refrigerator upright.
Open the upper door to take out all
door racks (to avoid damaging the racks) and
then close the door.
-11-
10
Summary of Contents for ELLIPSE ERBM104S
Page 20: ......
