corbeil ELLIPSE ERTM116W, Instructions Manual

3.

INSTALLATION INSTRUCTIONS (continued)

3.1 Positioning 

When selecting a position for your unit, you should make sure the floor is flat and solid so as to support the load and 
that the room is well ventilated. Avoid locating your unit near a heat source, e.g. stove, boiler or radiator. Also avoid 
direct sunlight as it may increase the electrical consumption. Extreme cold ambient temperatures may also cause 
the unit to not perform properly.  This unit is not designed for use in a garage or outdoors.  Do not drape the unit with 
any covering. When installing the unit, ensure that 3 inches of free space is left at both sides, 1 inch at the rear and 
1 inch at the top of the unit. This will allow cool air to circulate around the refrigerator and improve its efficiency

. 

3.2 Door Space Requirements 

The unit's door must be able to open fully as shown.  Please refer to the 
measurements below and to the illustration. 

W 

×

× 

D  

≥

990 x 1025 mm (39’’ x 40 ¼’’) 

D

 W  

3.3 Levelling the Unit 

To make this adjustment, use the two levelling feet at the front of the 
unit. If the unit is not level, the door and magnetic seal alignments will 
not meet up properly.  Drop down from the top, clockwise and 
counterclockwise, loosening or tightening. 

3.4 Cleaning before use 

Wipe the inside of the unit with a light solution of baking soda and water. Then rinse with warm water using a 
wrung-out sponge or cloth. Wash the shelves and vegetable crisper bins in warm soapy water and dry completely 
before replacing in the unit. Clean the exterior of the unit with a damp cloth. If you require more information refer 
to the CLEANING section. 

3.5 Interior Accessories 

Various glass shelves and/or plastic storage bins are included with your appliance - different models have different 
combinations. 

You should always slide one of the full-sized glass storage shelves into the lowest set of guides, above the fruit and 
vegetable bins and keep it in this position. To do this, pull the storage shelf forward until it can be moved upwards 
or downwards and then removed.  Do the same in reverse if you wish to insert the shelf at a different height. 

In order to make full use of the volume of the fresh food storage compartment and of the frozen-food storage 
compartment, the user can remove one or more shelves and/or drawers out of the appliance, to better suit your 
needs

. 

19