4. REVERSING THE DOORS
Tool required: Philips screwdriver, flat bladed screwdriver, hexagonal spanner.
x
Ensure the unit is unplugged and empty.
x
To take the door off, it is necessary to tilt the unit backwards. You should rest the unit on something
solid, so that it will not slip during the door reversing process.
x
All parts removed must be saved to do the reinstallation of the door.
x
Do not lay the unit flat as this may damage the coolant system.
x
It’s better that 2 people handle the unit during the assembly.
FREEZER DOOR
1. Unscrew the top hinge cover (see figure 1).
2. Remove the top hinge cover.
3. Loosen the top hinge screws with Phillips head screwdriver.
4. Adjust the door or put a spacer in between and then tighten the screws.
5. Replace the top hinge cover.
6. Move the hinge cover from left side to right side.
REVERSING THE DOOR SWING
Left/right door opening method:
This product allows you to reverse the door opening from left to right and back. You can select your preference of
door opening by following the procedure to make the change.
Dismantling (see figures 1 and 2):
1. Close shut the refrigerator and freezer doors with adhesive tape on both sides to hold the doors in place.
2. As shown in figure 1, remove the hinge cover screw on the upper part of freezer door with a Phillips head
screwdriver. Then remove the three screws that hold the hinge. Take out the hinge by pulling it vertically
and set it aside in a safe place.
3. Remove the adhesive tape on freezer door, lift and take off the door and carefully set it aside.
4. Remove all the screws of the middle hinge, lift and take off the middle hinge and keep all hinge parts in a
safe place.
20
Summary of Contents for ELLIPSE ERTM116W
Page 26: ... 3 ...
