CORBERO CV 1600 S/2, Instruction Book

24

Regular cleaning

It is practical to clean the inside of the freezer and

defrost it at a time.
Household cleaner or soap must not be used.
After breaking the circuit wash the appliance using

lukewarm water and wipe it.
Clean the door gasket with clean water.
After cleaning apply voltage to the appliance.
It is recommended to remove the dust and dirt

collected on the back of the appliance and the

condenser once or twice a year.

When the refrigerator 

is not in use

In case the appliance will not be used for a long time

follow these steps:
Break the circuit of the appliance.
Remove foods from the refrigerator.
Defrost and clean it as written before.
Leave the door open to avoid a build up of air inside.

Trouble shooting

During operation of the appliance some smaller but

annoying trouble can often occur, which does not

require calling a technician out. In the following

chart information is given about them to avoid

unnecessary charges on service.
We draw your attention that operation of appliance

goes with certain sounds (compressor- and

circulating sound). This is not trouble, but means

normal operation.

We draw it to your attention again that the

appliance operates discontinuously, so the

stopping of compressor does not mean being no-

current. That is why you must not touch the

electrical parts of the appliance before breaking

the circuit.

Problem

The appliance does not

cool sufficiently

The appliance cools too

hard
The appliance does not

cool at all

The appliance is noisy

Possible cause

Thermostatic control is set too low.
Before freezing the appliance was not precooled

sufficiently.
Large-sized food was put in.
Too many foods to be frozen were put in.
Warm foods were put in.
Door is not shut properly.
The thermostatic control is set too high.

Plug is not connected to the mains socket

properly.
There is no voltage in the mains socket.
Thermostatic control is in „0” position.
The appliance is not supported properly.

Solution

Set higher position.
Pre-cool the appliance for enough time.

Cut up food.
Put fewer foods to be cooled.
Put foods max. at room temperature.
Check if the door is shut.
Set lower position.

Check if the connection is proper.

Check if there is voltage.
Check setting of thermostatic control.
Check if the appliance stands stable (all the four

feet should be on the floor).

Inasmuch as the advice does not lead to result, call the nearest brand-mark service.

GB