CORBERO CV 1600 S/2, Instruction Book

27

Change of door opening direction

Should the setting-up place or handling demand it,

door-opening direction can be refitted from right-

handed to left-handed.

Appliances on the market are right-handed.
Following operations are to be done on the basis of

figures and explanations:

Break the circuit of the appliance.
Tilt back the appliance carefully being careful so

that the compressor cannot touch the floor. It is

recommended to ask another person for help, who

can keep the appliance at this position safely.
Remove carefully (e.g. with a knife) the covering

nails of screws fixing the bottom cover grid, then

the cover grid can be removed by unscrewing the

plate-screws (2 pieces).
Dismount the bottom door holder by removing the

screws (2 pieces) and the fill plates (2 pieces).
Take off the door by pulling it slightly downwards.
Unscrew the top door holding pin and put it to the

other side.
Fit the door to the top door holding pin.
Screw the bottom door holders on the other side

being careful that the edge of the door is parallel

with the edge of the mantle.
Screw the bottom cover grid back using the plate-

screws (2 pieces), then put the covering nails back.
Pull out the cover element of the cover grid in the

direction of arrow (1) and place it and contrary side

(2).
Put over the handle on the other side and put the

plastic covering nails into the holes set free.
Put the appliance to its place, set it level and apply

voltage to it.

In case you do not want to perform the procedures

above, call the nearest brand-mark service.

Technicians will accomplish the refitting expertly for

charge.

GB