Page 7
PROCEDURE
1.
Unpack all parts and inspect for
damage.
2.
Route the wires through the mast
beauty ring (740-9382-XX), then up and
out of the top of the mast.
3.
Once the wires are routed, insert the
mast (740-9370) into the base frame.
Fig. 6
Assembly instructions cover either 10” touchscreen or LCD console. For 15” Embedded, please see the
console manual 620-8816 for additional wiring and configuration information.
Required Tools:
• Metric Socket Set
• Metric Allen Key Set
• Torque Wrench
• #2 Phillips Screwdriver
• 3/4” Open-ended Wrench
• 9/16” Open-ended Wrench
IF INSTALLING PVS - PLEASE REFER TO PVS INSTALL INSTRUCTIONS FOR ROUTING THE COAX
CABLE BEFORE CONTINUING WITH UNIT BASE ASSEMBLY.
ASSEMBLY
SCAN TO WATCH A VIDEO
SHOWING THE ASSEMBLY
OF THIS CROSSTRAINER
