Page 9
7.
Use a 19mm socket and a 19mm open-
ended wrench to secure the handlebar
to the tie rod using one (1) piece each
of the M12 x 45mm hex head screw
(110-4138) and the M12 nyloc nut (110-
3929), and two (2) pieces of the M12
flat washer (120-3411).
8.
Repeat Step 6 & Step 7 for the right
side handlebar (740-9358-XX).
Fig. 10
9.
Use a short or 90-degree #2 phillips
screwdriver to secure the right side tie
rod shrouds (740-9553-XX + 740-9554-
XX) to the joint where the tie rod and
handlebar meet using three (3) pieces
of the M4.2 x 38mm pan head screw.
10.
Repeat for the left side tie rod shrouds
(740-9551-XX + 740-9552-XX).
Fig. 11
11.
Use a 5mm allen key to secure the
display weldment (740-9350) to the
mast using four (4) pieces each of the
M8 x 15mm button head screw (110-
4023) and M8 flat washers (731-0355).
Fig. 12