Communication cable must be tested and verified during installation at
each desired locations. All cables are test for open, short and color
matching. From controller to junction with daisy-chained wiring should
be all straight connection at junction box terminal.
IONIZER USER MANUAL
13
7
Setup and Operation
Yeollow
Green
Red
Black
Link IN - Wiring Cable
No.
1
2
3
4
BLACK
RED
GREEN
YELLOW
AC Return
Power VAC
RS485A
RS485B
Color
Description
Emitter rods are removable and shipped uninstalled with the emitter.
To install the rods, insert the end of the rod into receptacle on the
emitter and rotate the rod 1/4 turn clockwise until it hits the stop.
Rod stablizing spacer provides support for emitter rods 600mm or
longer.
Junction Box Wiring
RJ-11 Terminal Wiring
Rod Stablizing Spacer
Installation Example
Do not connect or disconnect emitters while the controller is powered!
Emitter rods are installed on all emitters.
Emitters are properly connected to the controller.
Cautions
