14
Copyright by CORE INSIGHT, INC.
This user manual contents may change without pre-notification.
F. Output Settings
Once all ceiling emitters are powered, it will operate at the factory
default mode. All ceiling emitters can be set differently to satisfy
different operating environments or needs within the same area.
Following sections described functions and features of ceiling emitters
on LED display. User can select operation on/off, high voltage on & off
time for both polarity, high voltage output levels by 0.1kV resolution,
cleaning alarm settings, power alarm setting and ID address.
7 Setup and Operation
n xxx(ID)
CIn.A
Id
HVP.A
Out
PHV.A
P.On
nHV.A
P.oFF
bur.c
n.On
I.dEL
n.oFF
PoS.V
START
VER
E. Powering the System
Once all systems in place and connected properly, turning on the
controller. When ceiling emitters and controller are powered, start LED
display and communication. Remote controller can assign ID address at
each ceiling emitters. Appropriate address can be asign between #001
and #120 without duplicated number. Controller will scan ID addresses.
nEg.V
