IONIZER USER MANUAL
15
To start communicating at each ceiling emitter, press START and ID address on
Model 5711R remote controller. Press FUN button for select output parameters.
LED will display as below and all parameters can be adjustable by UP/DOWN.
Once user changed any parameter, press FUN to store value in memory and
make changed value operational.
2) ID Address
Press FUN and UP/DOWN or press any number for set ID address on remote
controller in three digits such as 001 or 010. LED will display as below.
Press FUN to store this ID set.
1) Remote Controller
User can adjust parameters from remote controller.
Press START to adjust parameters
Press FUN to parameter modes and save value
Press NEXT to move next parameter mode
Press UP to increase selected parameter value
Press DOWN to decrease selected parameter value
User selectable value input from 0 to 9 for voltage and time
Parameter adjustment finished, press END for exit.
*If user did not press FUN, adjusted value will not store and
back to previous set value.
UP
DOWN
0-9
END
NEXT
FUN
START
7
Setup and Operation
