16
Copyright by CORE INSIGHT, INC.
This user manual contents may change without pre-notification.
4) Positive Voltage On and Off Time
Press FUN and NEXT (2
times
). P.On will display.
3.5 sec is factory default set value. Press UP/Down or type numeric value up
to 15.0 seconds maximum. Press FUN to store this set value.
Press FUN and NEXT (3
times
). P.oFF will display.
0.0 sec is factory default set value. Press UP/DOWN or type numeric value
up to 10.0 seconds maximum. Press FUN to store this set value.
3) Output On/Off
Press FUN and NEXT, output On/Off parameter will display.
On is factory default set for initial enable mode. Press UP/DOWN to change
individual ceiling emitter on or off. Press FUN to store this set.
5) Negative Voltage On and Off Time
Press FUN and NEXT (4
times
). n.On will display.
3.5 sec is factory default set value. Press UP/Down or type numeric value up
to 15.0 seconds maximum. Press FUN to store this set value.
Press FUN and NEXT (5
times
). n.oFF will display.
0.0 sec is factory default set value. Press UP/DOWN or type numeric value
up to 10.0 seconds maximum. Press FUN to store this set value.
7 Setup and Operation
