18
Copyright by CORE INSIGHT, INC.
This use manual contents may change without pre-notification.
10) High Voltage Power Alarm Level set
Press FUN and NEXT (11
times
). PHV.A will display.
After user changes the HVP alarm mode to On, positive factory default set
range applied as ±20% value.
Press FUN and NEXT (12
times
). nHV.A will display.
After user changes the HVN alarm mode to On, negative factory default set
range applied as ±20% value.
*If user want to set it to other value, type numeric value on remote controller.
11) Audio Alarm on/off
Press FUN and NEXT (13
times
). bur.c will display. Off is factory default set as
disable mode. Press UP/DOWN to adjust set from off to on mode.
Press FUN to store.
12) ID Delete and Change
If user wants to disable one of ceiling emitter from controller or change
address ID, Press FUN and NEXT (14
times
). I.dEL will display. Press UP/DOWN
to adjust set from off to on mode. Press FUN to store.
13) Firmware Version Display
Press FUN and NEXT (15
times
). VER will display.
7 Setup and Operation
