Copyright by CORE INSIGHT, INC.
This user manual contents may change without pre-notification.
19
Press FUN switch and click NEXT switch. Then FND will
display as follows and all parameters can change press
UP/DOWN switches. Once you change parameters, press
FUN again and setting stored.
1)
Power ON/OFF
Press FUN and UP/DOWN, FND will display as below.
2)
Frequency
Press FUN and press NEXT, FRE will display. 30Hz is
default factory set. Press UP/DOWN to change value.
3)
Positive Output Ratio Adjust (Duty Cycle)
Press FUN and press NEXT(3
rd
), Po.R will display. 99%
is default factory set. Press UP/DOWN to change value.
Press NEXT(4
th
), Ne.R will display. 99% sec is default
factory set. Press UP/DOWN to change value.
4)
High Voltage Positive Output Adjust (Duty Cycle)
Press FUN and press NEXT(5
th
), Po.V will display. Press
UP/DOWN to change value.
